GentExpert Technical Forum FAQ

Here you can find answers to questions about how the board works. Use the links or search box below to find your way around.

S3 MK1 speech, setup up for bell tone

Problem:
S3 MK1 speech sounder, and want the bell tone, how to set up?

Solution:
Comm tool, S-cubed mk1 config, select loop you are working on, right mouse click on the sector signal you want to setup, in new window tick tone, then high & low tone to tone 1, ok This should then give you a value of 11 in the sector signal box you have just set up.

S3 MK2 & S4 speech, set up for bell tone

Problem:
S3 MK2 & S4 speech sounder, want the bell tone, how to set up?

Solution:
Comm tool, S-quad / S-cubed mk2 config, in the tree select the loop and sector you are working on. In the signals section set high and low tone to 01 for the required signal. Ensure that both sounder and speech are ticked. click OK

Disable/enable device

Problem:
How do I enable/disable a device/outstation?

Solution:
Menu
Control
Usercode
Enable/Disable
Device/Outstation(number)
Loop(number)
Enter.

Once the device has been disabled, the panel will display a warning light to warn the user of this.

Safe addressing

Problem:
How do I SAFE address a device/loop on the panel?

Solution:
Menu
Test/Eng
Usercode
SAFE(enter current address or range)
Loop(enter number or range)
Address(enter address or range that you want the devices SAFE addressing to).

The system should be reset after this procedure.

To reverse SAFE addressing follow the above but on the last part enter address 0. This will revert the devices/loops selected back to soft addressing.

Search FAQ

Select this option if you would like your search to look in the text of FAQ items as well as their titles.

Select an option here to specify how you would like your search query to be treated. 'Any words' will return the most numerous but possibly least relevant results, while 'Complete phrase' will return only results that contain exactly what you are searching for.